No Gantry motions on Ventri via the RCU
Symptom
No Gantry motions on Ventri via the RCU No Gantry motions on Ventri via the RCU. System reboot had no effect. Gantry reset would pass but system startup would fail. Checking the error logs revelaed the following -Communications error with Gantry Control Unit -Internal motion sw error -Last axis movement failed -Comm/sync error with {0} -Cannot perform the requested operation because gantry is not ready Diags on the GCU internal test failed the following -GCU voltage test -Battery Ram memory test -GCU interrupt test -FPGA Bus test Contributor 212004100 Frastaci March 20 2007
Error message
STSMANGER_GCU_COMM_FAILURE:.:Communication error with the Gantry Control Unit.:.:1. Perform full shutdown. 2. Perform Gantry reset. 3. Perform PC reboot.:.: Communication failure with the GCU board (no TCP/IP connection):.:Trace:{0}Applies to
- Product
- Ventri Ventri Ventri
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop