GE Healthcare · Nuclear MedicineMillennium
Millennium Table longitudinal will not move in or out, error #9 Table will not move with handset or automatic…
Millennium Table longitudinal will not move in or out, error #9
Symptom
Millennium Table longitudinal will not move in or out, error #9 Table will not move with handset or automatic motions.
Error message
Error #9 (Error 9) Following error Motion ended because of a following error. Error #9 (Error 9) Following error Process gip_mx: Motion ended because of a following error
Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Component
- *Gantry Gantry Gantry 2146498 Millennium Gantry AMPLIFIER AXIS DRIVE CARD 2146498 Millennium Gantry AMPLIFIER AXIS DRIVE CARD 2146498 Millennium Gantry AMPLIFIER AXIS DRIVE CARD *IPS IPS IPS
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size