GE Healthcare · X-ray R&F
8535/8735/8835SFD Service Note 3357 Preventing Ball Bearing Damage or Loss When Removing or Installing Spot Film Device…
8535/8735/8835SFD Service Note 3357 Preventing Ball Bearing Damage or Loss When Removing or Installing Spot Film Device in Vertical Tower Carriage Assembly
Symptom
Ball bearings can fall out of bearing pillow blocks as the Spot Film Device is removed from the Carriage Assembly and jarred loose or damaged at installation.
Applies to
- Component
- 8535SFD 8835SFD
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug