GE Healthcare · X-ray R&F
88S/85SFD 8835/8535SFD Service Note 3139 Hall Effect Power Assist Handles
Symptom
Two errors were found in the information in the addenda after distribution of Service Note 3139. These errors were as follows: The jumper tables for JP1, JP2, JP3 and JP4 were in error in the instructions in Chapter 6 and on the 46-264316G1 schematic in Chapter 7 on both addenda. (All jumper positions were specified backwards.) (The gain adjustment statements should not have referenced adjusting for pounds of force.)
Applies to
- Component
- 8535SFD 8835SFD
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug