Need to acquire Second Order Spatial Correction for Cobalt but movepeak command is not working.
Symptom
Need to acquire Second Order Spatial Correction for Cobalt but movepeak command is not working. Trying to use movepeak command to create a new spatial correction to be used for cobalt second order correction with Tc99m isotope, movepeak is not working. Followed information in MG Service Manual 2412353-100 rev 4 section 6.4.7.20 - Alternate Method for Generating Simulated Isotope Peaks A script in the PMT directory offers a quick method to generate PM tuning files for artificial energies. 1. Open an Xterm window. 2. Enter the PMT directory, and type movepeak .The following guide appears: use: movepeak but instead of expect response get message "command not found". Generated Itrack # 13093424.
Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Software
- GenieAcq R4.5 V14 (M4) Genieacq 4.5 Build 14 (M4) 5220379 Genieacq SW R4.5 V014 M4 with accumulative patches GA450-05-1, GA450-6-1, GA450-07-0, GA450-08-1, and GA450-09-0 for Spare Part GENIE Acq R 4.5 V014 supports EDI and I/N board hardware configurations. The following computer platforms are supported by this version: SuperMicro P4SBR ( only supports the EDI detctor, reference SN43628 ) IBM x205 Dell 1400SC Dell GX200 Dell 1300. Dell 2200 and Intel AltServer are not supported. Reference CIS 5150522-100_r2 GenieAcq R4.5 V10 (M3) Genieacq 4.5 build 10 Genieacq 4.0 Genieacq 4.0
- Component
- *Software Software Software
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size