GE Healthcare · X-ray R&F
ADXE Monitrol RFX/SFX Legacy Counterweight take up cable problems
Symptom
ADXE Monitrol RFX SFX Legacy Counterweight take up cable problems The Take-up Counterweight Cable, which controls the height of the Spot Film Device on the Tower, can have broken strands but not show any signs of breaks until the weight is taken off of the cable. Then internal broken strands can be seen. This cable works in conjunction with the main Spot Film Counterweight Cable through the Pulley Assembly on the Inner Carriage.
Applies to
- Product
- Table
- Component
- RFX SFX table Legacy Table
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug