GE Healthcare · X-ray R&F
Legacy No table or wall bucky exposure.
Symptom
Legacy No table or wall bucky exposure. No error codes. The real time bus cable not fully seated in the positioner cabinet. Legacy new install. No exposure to table or wall bucky. No error codes. Get prep, grid oscilates when the exposure switch is depressed. Wall bucky or table bucky ready signal is at the A9 interfiace card just before it goes into the bus line. Ultranet collimator has a green light and collimated to the correct size. Same problem with AEC or Non AEc exposures. Ran diagnostics Realtime bus tests. Test failed.
Applies to
- Product
- Table
- Component
- Legacy Table
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug