Where Should the CAN Link be Terminated for HFO4/5 Systems?
Symptom
Where Should the CAN Link be Terminated for HFO4/5 Systems See Long Description. The Terminator is not installed where the Interconnect Diagram specifies. There is confusion about where the end of the CAN Link should be terminated on HFO4 and HFO5 systems. The HFO4, HFO5, and HFO5 Upgrade System Cabinets are delivered with the CAN Link Terminator applied to J5 of the Z2 Shim Supply internal to the cabinet, and there is no instruction to move it. But as shown in the cable map on page 5-6 of section "CABLE & SYSTEM INSTALLATION" of Direction 2402693, "Signa OpenSpeed EXCITE System Installation", Revision 3, it is supposed to be connected to J56 of the System Cabinet interface panel. Which is right? See Resolution concept for the complete SMILe released 11-27-06. (PQR # 13074785) 13074785
Applies to
- Models
- Signa
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR5-HFO5 Open Speed with Excite Product
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.