GE Healthcare · X-ray R&F
Unable to connect to the MPH with the laptop and run any calibrations.
Symptom
Unable to connect to the MPH with the laptop and run any calibrations. FE is able to get to the initial screen and select F2 for calibration but is unable to get into the calibration menus. Just the Triangle button is flashing on the laptop screen in the upper right hand corner, usually when the laptop is not communicating with the MPH the 2 upper right hand buttons are flashing.
Applies to
- Product
- Prestige II
- Component
- MPH GPX PRESTIGE TABLE
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug