GE Healthcare · X-ray R&F
PROTEUS Install, Hospital Power Issue
Symptom
PROTEUS Install - Major power problem When the unit was turned on, the wall breaker and power vault CB tripped. Tried disconnecting the L1, 2 and 3 leads to the Generator and the system powered up. The EMC Filter Board and AC/DC Boards were replaced. System worked fine until the modes were switched, then CB blew again. Check the DC power connection next to the Stator Cable connection. Reprder tje EMC amd AC/DC boards, and the HV section of the Jedi.
Applies to
- Product
- PROTEUS XRa
- Component
- JEDI Generator This generator is used on Proteus and Precision 500D systems.
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug