GE Healthcare · X-ray R&F
PROTEUS JEDI Filament Error 50-0204
Symptom
PROTEUS In addtion to the X-ray tube, not in auto mode, check if one of the filiments are broken by running the heater test. While looking at the heater board, ran the test and found that the LF was good and the SF caused errors.
PROTEUS JEDI Filament Error 50-0204 Customer reports intermittent Error 50-0204 (Filament permanent open circuit).
Error message
Error 50-0204 Jedi Filament
Applies to
- Product
- PROTEUS XRa
- Component
- JEDI Generator This generator is used on Proteus and Precision 500D systems.
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug