GE Healthcare · X-ray R&F
PROTEUS SIEMENS Collimator sizing problems
Symptom
PROTEUS SIEMENS Collimator sizing problems The collimator will properly size to the cassette in the table bucky. However; the following occurs in a table top mode at a 40 inch SID with the Collimator knobs set to the completely closed position: 1. The collimator display shows that the blades are fully closed (.9 inch X .8 inch). 2. The actual Collimator blades are showing a 7 inch by 7 inch light field on the table top.
Applies to
- Product
- PROTEUS XRa
- Component
- Collimator Siemens for Proteus, Precision, Revolution
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug