GE Healthcare · X-ray R&F
PROTEUS JEDI Error 70-0510 no AEC exposures
Symptom
PROTEUS JEDI Error 70-0510 no AEC exposures After turning system power on, the system would take manual exposures fine. As soon as AEC shot was taken, error 70-0510H was displayed and no more exposures were allowed, AEC or manual. With console power cycle the error would go away and could repeat above scenario. Upon investigating the error log also noticed error warnings with 27 as the code. 70 510 0510
Error message
Error 70-0510 no aec exposures
Applies to
- Product
- PROTEUS XRa
- Component
- JEDI Generator This generator is used on Proteus and Precision 500D systems.
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug