GE Healthcare · X-ray R&F
AMX 4 - Unit moves very slowly in drive mode.
Symptom
AMX 4 - Unit moves very slowly in drive mode. The FE has replaced the Drive Control Board and the Drive Power Amp Board. The unit tries to drive, but basically does not drive, it seems like the brakes are on. When the manual brake button is utilized, the brakes release and the unit drives at the proper speed. Reference page 3 of the Drive Power Amp Board: The K145 relay is coming in when the handle is twisted. The only remaining difference is the relay uses +BAT SWITCHED signal to release the brakes.
Applies to
- Product
- AMX4+ Portables AMX4
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug