AMX 4 - Unit will not turn on and off normally.
Symptom
AMX 4 - Keyswitch off, circuit breaker off then turns the circuit breaker on - the unit will power up but gives an error: Xray Disabled. Circuit breaker off, keyswitch on - turns on circuit breaker unit will power up w/o errors. If the FE has the keyswitch off and the circuit breaker off and turns the circuit breaker on, the unit will power up but gives an error: Xray Disabled. If the FE has the circuit breaker off and the keyswitch on and turns the circuit breaker on the unit will power up without errors and function normally. Once the unit is up it will not turn off with the keyswitch.
Applies to
- Product
- AMX4+ Portables AMX4
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug