GE Healthcare · X-ray R&F
MPX MVP 8835SFD error code 1095 during power up
Symptom
MPX MVP 8835SFD error code 1095 during power up NonAdvantx 8835/8535 spot film device displays error 1095 "Checksum calculated for calibration data in working ram does not match checksum in NVRAM." Associated error codes that may also be reported are 056 Non-volatile RAM write/read test failure and 057 Nonvolatile RAM Checksum failure.
Error message
MPX MVP 8835SFD error code 1095 during power up
Applies to
- Product
- MPX
- Component
- 8835SFD
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug