GE Healthcare · X-ray R&F
MPX R&F system, Intermittent no READY light after fluoro exposure
Symptom
MPX R&F system, Intermittent no READY light after fluoro exposure MPX R&F system, intermittent no READY light. When the system is turned on MPX Console READY light is ON. Exposures are allowed in RAD and Spot film mode. After a fluoro exposure is initiated and a spot film is taken, no rad or spot film exposures are allowed. READY light goes off due to loss of filament current. Relay MG3A4K19 REC to FL TRANS FIL CKT INTR is energized. If you tap on the relay, the relay drops out and READY light turns back on.
Applies to
- Product
- MPX
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug