GE Healthcare · X-ray R&F
MPX L300 no 105 exposures.
Symptom
MPX L300 no 105 exposures. No 105 exposure, fluoro and spot films were ok. The problem was traced to no image gate movement during prep of the 105 camera. If the switch (152 on the mx1a14a1) that is used to swap positions of 105 and camera for a two port system was actuated, the image gate switched normally, the only difference was an inverter on that card. It was found to be bad. PHOTOSPOT
Applies to
- Product
- MPX
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug