Ultranet SN 3299 Ultranet SA Collimator Setting the current feedback pots for Servo Damping
Symptom
What is the proper procedure to set the Current feedback pots for Servo Damping on an Ultranet SA Collimator To set up the current feedback pots P1 and P2 on PWA 45296175 for servo damping. The current revision of the system steering guides does not call out the servo damping adjustment. Since a particular collimator head and electronics are not tested together in the factory, the servo damping must be adjusted at the customer site during installation. The steering guides will be updated at their next revision.
Applies to
- Component
- Collimator Ultranet
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug