GE Healthcare · X-ray R&FRevolutionDefinium1000011
Def8000, XRd2X Error 1000011 when trying to calibrate the wallstand at 0 degrees.
Definium 8000 and Revolution XRd2X (Lighting) Wallstand calibration at 0 degrees
Symptom
Def8000, XRd2X Error 1000011 when trying to calibrate the wallstand at 0 degrees. Error happens in step 3 when the FE tries to make an exposure.
Error message
Error 1000011
Applies to
- Models
- Revolution, Definium
- Product
- Revolution XRd2X Definium 8000
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- Revolution XR/d After a Load From Cold, the AWS exhibits strange operation and the SUIF does not have any Positioner Configuration and Calibration selections due to the use of the incorrect Jumpstart…
- Definium 8000 Auto positioning does not work after a reset/reboot due to wall stand receptor at a hard limit during rebooting or repowering.
- Definium 8000 One or both monitors display the following message on every boot
- Definium 8000 Wallstand or Table Only Configurations running VolumeRAD M3 Software.