AMX 4 - SN3335 Main Circuit Breaker Wiring Correction

AMX 4 Wiring error on the main circuit breaker 1A3 CB1. SEE LONG DESCRIPTION AMX-4 A wiring error has been discovered on the AMX-4 main circuit breaker 1A3 CB1 that leaves a small section of the AMX unit electrically under-protected. The RED wire for the +BATT SWITCHED signal, located between the 8 Amp breaker (pole #2 of 1A3 CB1) and the charger board J2-5, is incorrectly connected to the "LINE" side of the 8 Amp breaker instead of the "LOAD" side of the 8 Amp breaker. One known single point failure is that if either of the brakes on the drive motors shorts out, the resulting high current will damage copper runs on the charger board.