GE Healthcare · X-ray R&F017326
AMX 4 - SN3249 CPU Board Jumpers & Switch Position Tabulation for Various Firmware Versions
Symptom
AMX4 - SN3249 CPU BOARD JUMPERS & SWITCH POSITION TABULATION FOR VARIOUS FIRMWARE VERSIONS The AMX-4 CPU board jumper & switch position tabulation in Section 1- 6 currently published AMX-4 calibration directions do not yet reflect how to set up for latest firmware 46-303272G1/46-303273G1. These calibration directions are "AMX-4 Calibration." Direction 46-0172 Revision 6, and "AMX-4 [Japanese Model No. 46-270157G4] Calibration" Direction 46-017326 Revision 0.)
Applies to
- Product
- AMX4 Portables AMX4+
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug