GE Healthcare · X-ray R&F
AMX 4 - Error 433 & 45F Generator Faults
Symptom
AMX 4 - Error 433 & 45F Generator Faults FE getting error 433 'Generator Fault: Leakage Compensation Command feedback was high after command was output during the prep cycle' and error 45F 'Generator Fault: Filament shorted signal did not go low after the filament was allowed to heat up during prep' when trying to make an exposure on the AMX4.
Error message
Error 45F Generator Fault AMX 4 Error 433 Generator Fault AMX 4
Applies to
- Product
- Portables AMX4+ AMX4
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug