GE Healthcare · X-ray R&F
AMX 4 - Cal Charger Error 3
Symptom
AMX 4 - Cal Charger Error 3 FE was getting CAL CHGR ERR 3 error when trying to calibrate the charger. After the systems asks to plug in the charger cord the "CONVERTING" message is displayed but never changes to "ENTER VALUE". FE sees 8.4 volts on the meter, way too high, the display changes to "REMOVE CHRG CORD" and then the error message "CAL CHRG ERR 3" is displayed.
Error message
Cal Charger Error 3 AMX 4
Applies to
- Product
- AMX4 AMX4+ Portables
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug