GE Healthcare · X-ray R&F
MVP3 Phase Generator L4 KVP calibration program default values
Symptom
MVP3 Phase generator, what are the L4 KVP calibration program default values In the MVP3 Phase Generator, the factory default, or initial values for coefficients AA and BB in the L4 kVp Calibration Program, are not published in the service manuals. If the L4 program is not done correctly, it may result in wrong values for AA and BB such as: AA=000 and BBB=999. Reload the default values for AA and BB and repeat the procedure for the L4 program.
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug