GE Healthcare · X-ray R&F
MVP3 Error 46 at Technic
Symptom
MVP3 Generator will not terminate exposure by Forced Commutation. Error code 46 is displayed on the console. MVP Three Phase Generator will not terminate exposure by Forced Commutation. Error code 46 is displayed on the console. This problem occurs at all mA stations and at low or high kVp. The charge across forced commutation capacitor C5 rises during prep from about 160 VDC to 205 VDC very slowly (several seconds).
Error message
MVP3 Error 46
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug