SILHOUETTE VR/PROTEUS - Short Circuit in JEDI HV Generator
Symptom
PROTEUS Silhouette VR / Proteus short circuit in JEDI HV Generator trips system, room and hospital breakers See long description. Catastrophic Failure of the Jedi HV Generator may trip hospital power vault breakers before and including system room disconnect A1 and Silhouette system PDU chassis ckt bkr 480 volt 3 phase. CAUTION: Turning on the 480 volts will only induce additional issues to the system prior to checking for direct shorts. NOTE: While some Proteus Jedi part numbers may be different (such as inverter), principles of troubleshooting apply to Proteus systems as well. Double check your part numbers prior to ordering for Proteus system.
Applies to
- Product
- PROTEUS XRa Silhouette VR
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug