GE Healthcare · X-ray R&F
MVP3 Error 43 Main Contactor opened during exposure.
Symptom
MVP3 Error 43 Main Contactor opened during exposure This eror means that the order equivalent to the one given to the Safety Contactor has the value corresponding to OPEN (low level) during exposure. This check is carried out during the entire exposure. This is a FATAL error code.
Error message
MVP3 Error 18 The Forced Commutation Board Does Not Operate Correctly MVP3 Error 43 Main Contactor Opened During Exposure
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug