MVP3 Error 18 Forced Commutation Board does not operate correctly
Symptom
MVP3 Error 18 The Forced Commutation Board does not operate correctly This error means that the EXP EN FC (pin 30 B) signal has a level which is not expected by the Power Unit Microcomputer board. This error may indicate that the Forced Commutation Board does not indicate enable 260 mSec after the order to connect the safety contactor was given or tht the EXP EN FC signal (pin 30B) is active without the contactor being connected. This check is done whenever the equipment is switched on. This error is considered recoverable for the system.
Error message
MVP3 Error 18 The Forced Commutation Board Does Not Operate Correctly
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug