MVP3 Error 17 The TIRC has not braked correctly
Symptom
MVP3 Error 17 The TIRC has not braked correctly. See long description. This error means that the TIRC has not braked. After sending the brake order, there is a wait time of 10 seconds for the TIRC to send the BRAKE code (001). When this time has elapsed, it sends the STOP code (000) unless it has sent a fresh command. This check will be carried out whenever entering the Preparation or Fluoro state when the TIRC is ordered to accelerate. This error is considered recoverable for the system and will disappear after being displayed by the console.
Error message
MVP3 Error 17: The TIRC Has Not Braked Correctly
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug