GE Healthcare · X-ray R&F
MVP3 Error 13 Failure in the VoltPac Relay Connection/Disconnection
Symptom
MVP3 Error 13 Failure in the Voltpack Relay Connection/Disconnection The Power Unit Microcomputer board checks that the VOLTPACK relay status acknowledgement signal MOT ENAB (pin 14A) matches the order MOTOR ENABLE (pin 23A). When a change is ordered in the status of the contactor, no check is carried out for 80 mS. This check is done whenever the equipment is switch on. This error is considered RECOVERABLE for the system.
Error message
MVP3 ERROR 13
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug