GE Healthcare · X-ray R&F
MVP3 Error 2 +15V Check Signal (38 A, B) Should Be On and is Off
Symptom
MVP3 Error 2 +15V Check Signal (38 A, B) Should Be On but is Off After starting the system, if all the checks are correct and there is no fatal error, the +15 V OFF signal is triggered. Then the system checks the +15 CHECK signal (38 A,B) and if it is not active, it will be a case of ERROR 2. This is a RECOVERABLE error.
Error message
MVP3 Error 2: THE +15V Check Signal (38 A, B) Should Be On and Is Off
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug