MVP3 Error 15 TIRC Not Accelerating Correctly
Symptom
MVP3 Error 15 - The TIRC has not accelerated correctly This error means that the TIRC has not accelerated. After sending the order to accelerate, there is a waiting period of 3 seconds for the TIRC to send the code that it has accelerated to High Speed or to Low Speed. If this does not happen, it will be a case of ERROR 15 and the BRAKE order will be sent to the TIRC. This check is done whenever entering the PREPARATION OR FLUORO status when the TIRC is ordered to accelerate. This error is considered recoverable for the system and it will dis
Error message
MVP3 Error 15: The TIRC has not accelearated correctly.
Applies to
- Product
- MVP 3 Phase
- Component
- Tirc
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug