MVP3 Error 67 Large Filament short circuit
Symptom
MVP3 Error 67 Large Filament short circuit See long description. The Large Filament Voltage has been detected as very low. Either the filament is shorted and the voltage is therefore zero or the filament control circuit is faulty. This check is carried out as long as the equipment is ON. This is a FATAL error code. If it is desired to short circuit the filament in order to troubleshoot, or to bypass the filament short circuit power up test, depress SW16 on the Power Unit Microcomputer Board, while turning on power to the system or while pressing the RESET switch SW32 on the same board.
Error message
MVP3: Error 67
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug