GE Healthcare · X-ray R&F
MVP3 Error 60 Detection that OVERLOAD bistable was triggered during an exposure.
Symptom
MVP3 Error 60 detection that OVERLOAD bistable was triggered during an exposure. It is detected that the OVERLOAD bistable has been triggered during an exposure. this bistable is triggered when the tube mA reading has exceeded the value of 1400 mA, i.e., there has been a "FLASH" or arc in the X-Ray Tube. This is a RECOVERABLE error.
Error message
MVP3: Error 60
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug