GE Healthcare · X-ray R&F
MVP3 Error 5 There is a failure of the Analog Digital Converter on the Power Unit Microcomputer Board
Symptom
MVP3 Error 5 Failure of the Analog Digital Converter on the Power Unit MIicrocomputer Board When the equipment is switched on or after a RESET. During normal operation. The test consists of measuring the voltage of the multiplexer channel 8 (U274 pin 9). This voltage should be +5 volts. It is obtained from the +15 V with a voltage divider and it reaches multiplexer U274 via an analog switch controlled by the SWAN signal. The tolerance of this voltage is +7% or -7% of 5 V. This is a FATAL error code.
Error message
MVP3 Error 5: Failure of The Analog Digital Converter On The Power Unit Microcomputer Board
Applies to
- Product
- MVP 3 Phase
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.
- P500D Aurora with M4 Software (May 2006 Release), Dose Readout Correct on Console, Dose Printer Prints 0.0 due to a M4 Software Bug