3D Fiesta Protocols Not Available on 1.0T System After Installing Flex Trial
Symptom
3D Fiesta Protocols Not Available on 1.0T System After Installing Flex Trial System is running 9.1 M4 Software. (The specific software revision running on this system is shown below.) This is a 1.0T HiSpeed system (Slew Rate 77). The customer downloaded and installed the 3D Fiesta FlexTrial option but then when trying to use it, found no GE protocols pertaining to this option. There is no error message seen or logged. See Long descrition to determine if fiesta3d flex trial has been loaded. We can see that this FlexTrial is loaded by performing the following command and checking its output. What we saw is shown below. /usr/g/bin/sok_test
Applies to
- Models
- Signa, HiSpeed
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.