GE Healthcare · Nuclear MedicineMillennium
No motions on Millennium Gantry, will not Calibrate motions after resetting gantry controller, detector two NOT AT 180 d…
No motions on Millennium Gantry, will not Calibrate motions after resetting gantry controller, detector two NOT AT 180 degrees.
Symptom
No motions on Millennium Gantry, will not Calibrate motions after resetting gantry controller, detector two NOT AT 180 degrees. In some cases, typically if gantry reset and AUI has not been started yet, can move table with hhc but no rotation or radial. Checked the Gantry EUI and found VG lock in unknown status.
Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size