How to short two pins together to check RRI Z2 Shim Power Supply Communication?
Symptom
How to check RRI Z2 Shim Power Supply Communication RRI power supply is used on Twinspeed or LX with FMI 60642. It is a resistive shim power supply that provides only one channel; Z2. The same supply is used as the High Order Shim Power Supply where multiple channels are provided. The system must have a BRM coil (or TRM) with resistive coil windings built in. Ordinary LX systems don't have one. See Long Description. Can't get the RRI (Z2) Shim Supply to communicate. To test communications from the host, the “cu” command can be used from a Cshell window as follows: cu shimsupply [enter]. If there's no response, there are two pins on cable Run 1004 connector at the shim supply that can be shorted together such that whatever is typed into the "cu" window will echo back. This will verify that everything up to the shim supply is working.
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.