RF Output Waveform is Severely Distorted and Very Low Power
Symptom
RF Output Waveform is Severely Distorted and Very Low Power with Erbtec RF Amplifier Looks bad, both at input and output of directional couplers. With APB bypassed, Erbtec Amplifier output waveform is no longer distorted, but very low amplitude. Verified tuning cap motor positions are ok, and tuning shafts not slipping. Swapped Solid State Amp board, still same problem. Verified adequate power is coming into the Solid State Amp from Exciter. Adequate power is coming out of Solid State Amp going into IPA section.
Error message
Erbtec 62 Fault Insufficient Power for AFT if AFT is attempted
Applies to
- Models
- Signa
- Product
- Signa Horizon (5X Horizon) 5X Horizon systems
- Software
- 5.X
- Component
- 46-305000P3 ERBTEC 176–1001 3CPX800A7 TUBE (IPA Tube)
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.