GE Healthcare · Nuclear MedicineMillennium
MG Under Genieacq AUI PPM control - when going from home to collimator exchange, going from collimator exchange to home,…
MG Under Genieacq AUI PPM control - when going from home to collimator exchange, going from collimator exchange to home, when changing from cardiac to whole body, and when changing from whole body to…
Symptom
MG Under Genieacq AUI PPM control - when going from home to collimator exchange, going from collimator exchange to home, when changing from cardiac to whole body, and when changing from whole body to cardiac, the system would halt during roll motion Contributor 212004424 Goodman March 02 2006 mailto:[email protected]
Error message
Motion sequence failed Error drive_fault 5 Reported on roll axis Motion sequence failed Error encoder_fault 87 Reported on roll axis
Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Component
- *Gantry Gantry Gantry
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size