GE Healthcare · MRSigna224458022445772244579
Ensure 9.1 M4A or Higher Revision Software is Loaded.
Symptom
T1 FLAIR sequence causes Gradient faults. Sometimes the scan pauses due to current distortion faults and other times it completes the scan with no IQ issues and just has gradient data overranges in the log.
Error message
2244580 "%" Axis Gradient Data Overrange Occurred Error: 2244580 Host: MR1SMR Process: NSP File: HPC_PORT_ID:GAP/GIP/GP Line: 1889 Y Axis Gradient Data Overrange Occurred.^A The GP detected an error in the incoming High Speed Data from the IPG. Swap fiber optics at the Systems Cabinet. Run fiber optic diagnostics. 2244580 Y Axis Gradient Data Overrange Occurred Y axis error occurs on T1Flair sagittal sequence 2244577 The GP reported a % Axis Current Distortion Fault 2244577 "The GP reported a Z Axis Current Distortion Fault. If no other faults occurred, check LCoil Calibration. Else, run Gradient Driver Tests to isolate the FRU. If Tests pass, see Troubleshooting Manual." 2244579 X Axis Gradient Data Overrange Occurred X axis data overrange error occurs on T1Flair coronal scans
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.