GE Healthcare · Nuclear Medicine
On Genie P&R reboot, system displays the "Select (b)oot or (i)interpreter
Symptom
On Genie P&R reboot, system displays the "Select (b)oot or (i)interpreter:" prompt along with the following error message every five seconds during the boot sequence: Run Error: File not found. could not run r Contributor 212004179 Brown February 15 2006
Error message
Genie Run Error: File not found "could not run r"
Applies to
- Product
- Genie Genie P&R Workstation Genie P&R Workstation
- Software
- Genie All All software versions of Genie All software versions of Genie
- Component
- *Software Software Software
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop