FMI 40763_0 Nov/02 Vision 6.0 for an LNX POWERstation Kit UGP001291
Symptom
FMI 40763_0 Nov/02 Vision 6.0 for an LNX POWERstation Kit UGP001291 FMI 40763 _0 Nov/02 Vision 6.0 for an LNX POWERstation Kit UGP001291 To provide the Repair Engineer with the information necessary to perform a mandatory upon request upgrade of all POWERstations running the Linux Operating System. This upgrade requires the Linux Mandrake 8.1 Operating System to be reloaded as well as the Vision software upgraded. Note 1: SMV Powerstation: Mandatory Safety FMI 40763 Vision 6.0.0 (11 April 2003 Build) is not complete within our SMV LNX POWERstation Install Base. Engineers are unaware the software is available or mandatory. It also has been determined that Vision 6.0.1 software has been installed over the incorrect build of Vision 6.0.0. -- Barkoot Note 2: Mandatory Safety FMI 40763 kits are shipped with the incorrect revision of Direction 2354938-100, Rev 2 rather than Rev 8 or greater producing an incorrect installation of LINUX OS. Use service manual 2354938-100, Rev 8 or higher when performing this upgrade -- Barkoot
Applies to
- Product
- SMV Powerstation SMV Powerstation SMV Powerstation
- Software
- LNX Powerstation Vision 6.0 LNX Powerstation Vision 6.0 (Mandrake 8.1) Software Revision: LNX Powerstation Vision 6.0 (Mandrake 8.1) Kit Part Number: UPG001291 FMI # / Service Note #: FMI40763 Mandatory on Request Comments: UPG001307 Software CD PKG
- Component
- *Software Software Software
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Mandatory on Request FMI 40763 Vision LNX Powerstation 6.0, kits UPG001291 are shipped with a currently outdated revision of Direction 2354938-100, Rev 2 producing an incorrect installation of LINUX O…
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2