GE Healthcare · Nuclear MedicineMillennium
No Gantry motions, fails to calibrate without moving.
Symptom
No Gantry motions, fails to calibrate without moving.
Error message
GIP Error: Too many NAK retries: Check gantry communications Sample of messages in Error log, ( type listerr in terminal window.) 2006/02/03 13:33:44 EET BUMCNM7478A:gip_mx;16:gip_recv.c[$Revision: 1.79 $] handleNack() line 667 error 0x07100008 level 2 severity 3 {} "Last message sent to controller by gip was: SZMO<00><00><00><01> " 2006/02/03 13:33:44 EET BUMCNM7478A:gip_mx;16:gip_recv.c[$Revision: 1.79 $] handleNack() line 669 error 0x0710000A level 2 severity 3 {} "Last message received from controller was: 0?Z<c9> " 2006/02/03 13:33:44 EET BUMCNM7478A:gip_mx;16:gip_recv.c[$Revision: 1.79 $] handleNack() line 671 error 0x0710000B level 2 severity 3 {} "Old Checksum sent with original msg: J " 2006/02/03 13:33:44 EET BUMCNM7478A:gip_mx;16:gip_recv.c[$Revision: 1.79 $] handleNack() line 677 error 0x0710000C level 2 severity 3 {} "New Checksum sent with retry: J " 2006/02/03 13:33:44 EET BUMCNM7478A:gip_mx;16:gip_recv.c[$Revision: 1.79 $] handleNack() line 667 error 0x07100008 level 2 severity 3 {} "Last message sent to controller by gip was: SZMO<00><00><00><01> " 2006/02/03 13:33:44 EET BUMCNM7478A:gip_mx;16:commcntl.c[$Revision: 1.60.10.1 $] send_cmd() line 275 error 0x07100002 Applies to
- Models
- Millennium
- Product
- MG/MC/Myosight Millennium MG/MC Millennium MyoSIGHT
- Component
- *IPS IPS IPS
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Need part numbers for the Millennium MG/MC table E-Stop
- How do I Delete a file on Genieacq that the system thinks is still acquiring
- VG, the contour works... but in the opposite way.
- MG_MC_MyoSight_MPR_MPS Bar Phantom Resolution Size