The Upper Coldhead Does Not Turn Off When Scanning.
Symptom
The Upper Coldhead Does Not Turn Off When Scanning. See long description. Coldhead cycling is not working, the upper coldhead does not turn off when scanning. FE did the setup on the SHEM and had the OLC successfully run a Checkout. Can telnet between the MR and the SHEM both ways. The magnet pressure and HE level are good so this should not be causing the failure to cycle the two stage coldhead. The following error is seen in the /usr/g/service/log/tcuErrors log: 06/10/2004 13:04: PMColdHead.cc:29 Comm with SHeM failed 06/10/2004 13:04: PMHost.cc:425 CH Status unchanged: Previous Status = Communication Fail, Current Status = Communication Fail
Error message
2225113 ColdHead switching not enabled during scan. Tue Dec 23 12:17:25 2003 Error: 2225113 Host: lx-mr Process: NSP File: HPC_PORT_ID:hpc_change_state Line: 40 ColdHead switching not enabled during scan. HPC was told to initiate a scan with the ColdHeads on. Image degradation is likely while this condition remains.
Applies to
- Product
- HF OpenSpeed HFO1 HFO2 and HFO3 Only.
- Software
- HFO3
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Cold Head Cycling Is Disabled During Scan.
- Magnet Monitor 3 installed to replace a SHeM.
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.