GE Healthcare · Nuclear Medicine
Can not print after load from cold
Symptom
Can not print after load from cold Can not print after load from cold. System backups were restored.
Applies to
- Product
- SMV Powerstation SMV Powerstation SMV Powerstation
- Software
- LNX Powerstation Vision 6.0 LNX Powerstation Vision 6.0 (Mandrake 8.1) Software Revision: LNX Powerstation Vision 6.0 (Mandrake 8.1) Kit Part Number: UPG001291 FMI # / Service Note #: FMI40763 Mandatory on Request Comments: UPG001307 Software CD PKG
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop