GE Healthcare · MROptima22247252224666
Auto and Manual Prescan Fails due to defective coil.
Symptom
Auto and Manual Prescan Fails
Error message
2224725 Low signal detected. Please check the signal level for receiver X (or receiver X while using Manual Prescan) See Long Description Error: 2224725 Host: hopgemr1a Process: NSP File: APS:aps_frame_range_check Line: 10 Low signal detected. Please check the signal level for receiver X (or receiver X while using Manual Prescan). 2224666 Auto Prescan failed, signal too small. Please try Manual Prescan. Fri Jan 23 14:39:55 2004 2224666 lx-mr psc PscMainControl.cc 1271 Auto Prescan failed, signal too small. Please try Manual Prescan.
Applies to
- Models
- Optima
- Product
- Optima MR450W Wide bore magnet. Not Discovery750 or Discovery450.
- Software
- 21.0 Only for Optima MR450W (wide bore) systems. (Not to be used on Discovery MR450 or Discovery MR750). Only for Optima MR450W (wide bore) systems. (Not to be used on Discovery MR450 or Discovery MR750).
- Component
- 5147225-2 1.5T HD Quad Extremity Coil Assembly. From the Direction 5144304, Rev# 4 Signa HDe 1.5T Service Methods. To view the most recent appropriate and detailed documentation, click to go to MR Service Documentation . Signa HDe 1.5T HD Quad Extremity Coil Table 1: FRU List Part# Description FRU Qty 5147225-2 1.5T HD Quad Extreity Coil Assembly Yes 1.0 5147225-3 1.5T HD Quad Extremity Phantom Yes 1.0 5147225-6 1.5T HD Quad Extremity Cable Assembly Yes 1.0 5147225-7 HD Quad Extremity Phantom Positioner Yes 1.0
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- CWA ID100513. Will Not Scan with Gradient Errors.
- Multicoil Bias Fault errors on multiple coils.
- Auto Prescan Failures and RF amp setup incomplete Errors Due to Defective RF amp.
- The system is unable to scan with any surface coil, get dynamic disable faults.
- CWA ID103384. Computer Will Not Boot with the message on the screen that says Do Not Interact With System.
- CWA ID103582. Unable To Scan With Driver Module Errors.