GE Healthcare · Nuclear Medicine
Ventri will not setup for scan getting failed to start sequence error.
Symptom
Ventri will not setup for scan getting failed to start sequence error.
Error message
Testing ADAM Board Communication Failed to write port 0x2800 ADAM #0 board on DOC board of detector #1 has failed the communication test Captured Errors : Testing ADAM Board Communication Failed to write port 0x2800 ! FRU: ADAM #0 board on DOC board of detector #1 has failed the communication test ! ADAM#0 board has failed the communication test ! Additional information :Failure occurred at detector #1 Results of detector communication diagnostics indicating adam failure- ADAM #0 board on DOC board of detector #1 has failed the communication testCaptured Errors : Testing ADAM Board Communication Failed to write port 0x2800 !FRU: ADAM #0 board on DOC board of detector #1 has failed the communication test !ADAM#0 board has failed the communication test !Additional information :Failure occurred at detector #1
Applies to
- Product
- Ventri Ventri Ventri
- Component
- UGP500114 (5272330) ADAM Board (Ventri, Infinia, VG) FE Assist: If PCA000464 or UGP500114 are not available order # 5272330 UGP500114 (5272330) ADAM Board (Ventri, Infinia, VG) FE Assist: If PCA000464 or UGP500114 are not available order # 5272330 *Detector (Imaging Detector) *Detector (Imaging Detector) *Detector (Imaging Detector)
- Area
- Nuclear Medicine
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare Nuclear Medicine issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare Nuclear Medicine issues
- Muga patch FMI 40788 when loaded does not indicate it completed
- How do I capture and print COR and Camera Uniformity (CUA) result screens on Genieacq, then send to a processing station for ACR
- Part number needed for Optima E-Stop
- Collision and E-stop lights are red on the back of the gantry and no movement with Hand Held Controller (HHC) or the genieacq.
- Service Note 43783_1 Feb/08 Infinia/Ventri/Xeleris 1.1 & 2
- Need part numbers for the Millennium MG/MC table E-Stop