Octane Computer Does Not turn on Due to the System Module in the Octane IP-30 System Board.
Symptom
Octane II Light bar Flashing Red Nothing Displayed and Can't Boot When replacing the Octane II computer, the FE installed the hard drives and System ID module over from the old computer, then FE powered the new Octane II computer up and was unable to boot. There is nothing displayed on the monitor, and the Octane II computer's lightbar started white, then changed to flashing red, and stays flashing red and nothing else happens. When replacing the Octane II computer, the FE swapped the hard drives and System ID module over from the old computer, then the FE powered the new Octane II computer up and was unable to boot. There is nothing displayed on the monitor, and the Octane II computer's lightbar started white, then changed to flashing red, and stays flashing red and nothing else happens.
Applies to
- Models
- Signa
- Product
- Signa LX Signa LX Product can be used with 8.x and 9.x systems.
- Software
- 9.1 For Signa LX product only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- CWA ID100315. Auto and Manual Prescan Fails.
- What is the Acoustic Noise Level in the Ovation Magnet.